JTC-4054 預熱塞鑽孔拆除器 @% TWJTC-4054
JTC-4054 預熱塞鑽孔拆除器 @% TWJTC-4054
Choose the NO. 4 socket, install it onto the glow plug,
use a hammer to fix the socket with glow plug head then
try to remove the glow plug with 3/8 " DR. spanner.
 This tool is especially for the situation when removing
the glow plug, but there is only head is removed then
please use the other accessories to remove the rest glow
plug hole and replace a new one
Insert NO.6 tube into the glow plug hole, then insert a
No.10 φ3.5 drill into NO.6 tube then drill a hole with air tool.
Separate the NO.9 device and only choose the cone center
tool and install it into the glow hole. Choose suitable drill
from NO.2 (7x 5.5 or 9x 5.5 or 8x 5.5), inert the drill into
NO.8 drill installer. It is important to sue NO.5 (3mm alley key)
to lock the screw on drill installer.
Then install it into cone center tool, and connect with air tool
to drill and also remove the hex nut from glow plug.
jtc-4054預熱塞鑽孔拆除器twjtc-4054 %
jtc-4054預熱塞鑽孔拆除器twjtc-4054 %
选择4号插座，安装于电热塞，
用锤子辉光插头然后固定插座
尝试着用3 / 8”扳手拧下火花塞。
这个工具是特别的情况时，除
电热塞，但只有头被删除的时候
请使用其他配件，删除其余的辉光
孔堵塞，更换一个新的
第六管插入到电热塞洞，然后插入一个
3.5号φ钻到6号管再钻一个孔与气动工具
单独的9号装置只选择锥中心
工具安装到发光孔。选择合适的钻头
从第二（7 9×5.5或5.5或5.5×8），钻入惰性
第八钻安装。这是苏5重要（3巷键）
锁螺丝钻的安装程序。
然后安装到锥中心的工具，并与气动工具连接
钻并除去辉光插头的六角螺母。 | 
您的位置：
银行汇款